Find A Low Price LNB, LNBF, LNBs Store
Be sure the vision aiming at the south sky is clear in the area of the elevated angle which you'll be locating the dish to. So if a setting for a area was 45 degrees, view the sky forty five degrees to be sure line of sight is without obstruction.
2. Attach the sat dish mast onto a inflexible area with coach bolts.
Implement at least 6 coach bolts to fit your dish mast. two inch lags for the corner mounts and use 3 inch coach bolts for the mid holes to a wall framing member. If you don't do this will result in wind damage which might pull and loosen the mast causing it to loosen the bolts grip and of course your dish will likely move out of alignment. Deploy a level so you can be certain that your mast is perfectly vertical at all the required angles. If you fail to, it will be harder for someone to set the tv dish in order to get a unbroken satellite signal. Once it's vertically plumb, firm up the bolts.
3. Mount your dish upon your dish mast.
Tighten all the fixings but only enough to eliminate all the sloppiness from your sat dish. Locate the location bearings which are obtained at the setup procedure for your receiver in regards to your local zip and modify the dish azimuth, dish elevation and skew as you need to. Deploy a compass pointer to obtain a nearest guess as far as azimuth. Don't fully tighten the coach bolts right at the moment; leave them loose so you can effortlessly adjust them after you hone your satellite signal.
4. Connect your signal meter onto your LNB Feedhorn cable that comes from the sat dish receiver.
For those who don't have a signal finder meter they can be brought through LNBShop.info, on the internet for just twenty dollars or so that buys a cheaper model. You can also make use of a sat receiver combined with a TV for a dish signal meter just by opting for the see signal strength selection whilst doing your initial setup process with your receiver. You might need some help to fine tune your sat dish deploying this method. Deploy the preset 101° orbital location and transponder 1, if you are DirecTV users following that Hit MENU, after that option 6, number 1, number 1 on the tv remote for Dish Network.
Grab your finder and adjust your decibal (db) level until you minimally find a slightly audible noise and then scan the southern sky so that you get a fair guage of the satellite location points. Remove your sat finder and attach the receiver line immediately to the lnb 4. If you are using a multi-switch then you will be required to attach a minimum of two lines of cable from the multiswitch into your lnb band subject to the type of satellite dish you've got. Click link to check out the full article on an easy method to set up your lnb feed horn plus a satellite dish tv arrangement